Polaris RANGER XP 700 4X4 Service Manual page 177

CLUTCHING
3. Separate the two clutch sheaves.
4. Inspect the helix and inner spring retainer on the moveable
sheave.
Inspect For Abnormal Wear
5. Remove the inner spring retainer from the inner sheave.
Inspect for wear and replace as needed.
Inspect For Abnormal Wear
6.20
6. Check the rollers in the stationary sheave for wear. If the
rollers are worn, a new driven clutch assembly may be
needed.
Check Rollers for Wear
7. Inspect the bearings inside the moveable sheave.
Inspect Bearings For Wear
Moveable Sheave Bearing Inspection:
Replace the bearing if more brass than
Teflon™ is visible on the bearing.
8. Inspect the Teflon™ coating on the moveable sheave
bearings.
9. Inspect driven clutch sheave faces for wear or damage.
10. Clean and inspect splines on helix and transmission input
shaft.
11. Lube splines with a light film of grease. Do not lubricate
the bearings!