Parking Brake Switch - Polaris RANGER XP 700 4X4 Service Manual

ELECTRICAL

Parking Brake Switch

The parking brake switch is located under the dash or under the
hood. Follow the parking brake lever under the dash to locate the
switch.
Parking Brake Switch
The switch remains in the "open" position when the park brake
lever is not applied.
The switch makes contact when the park brake is applied and
sends voltage to the ECU and Speedometer to illuminate the
"Park Brake Indicator" near the top-center of the instrument
cluster.
Parking Brake
Applied
10.6
Parking Brake
Not Applied
TESTING PARK BRAKE SWITCH
1. Disconnect the Orange/Red wire and Red/White wire from
the switch.
2. Place the ohmmeter leads onto terminal leads A and C. The
reading should be infinite (•).
RD/WH
OG/RD
3. Apply the parking brake. There should be continuity
between the switch terminals. If no continuity exists when
the park brake is applied, try to clean the switch terminals
and re-test. Replace switch if necessary.
Park Brake
Indicator
P
Key-On
Power