All Wheel Drive (Awd) Coil; Operation Overview; Diagnosing System Failures; Gear Position Indicator Switch - Polaris RANGER XP 700 4X4 Service Manual

ELECTRICAL

ALL WHEEL DRIVE (AWD) COIL

Operation Overview

• When the AWD switch is "ON", 12 VDC power is
present at the hub coil.
• If the criteria is met, the instrument cluster provides a
ground path at pin #16. When this occurs the AWD
icon should display in the instrument cluster.
• The AWD system must be grounded to operate.

Diagnosing System Failures

• Verify the AWD switch is functional and that a
minimum of 11 volts is present at the hub coil.
• Verify the AWD hub coil is functional. Test the AWD
hub coil using an ohm meter. See specifications below.
AWD Hub Coil Resistance:
24
• Verify the wiring harness, wiring, connectors,
connector pins and grounds are undamaged, clean and
connect properly.
• Verify continuity of wire connections with a known
good volt/ohm meter.
IMPORTANT: Verify all wires and wiring connections
have been tested properly with a known good volt/
ohm meter before suspecting a component failure.
80% of all electrical issues are caused by bad/failed
connections and grounds.
10.16
Ω
± 5%

GEAR POSITION INDICATOR SWITCH

Test Diagram

NOTE: Also see "INSTRUMENT CLUSTER
TROUBLESHOOTING" for switch circuit.
TRANSMISSION SWITCH
High / Low / Neutral / Reverse Switch
High Range
Low Range
Neutral
Reverse
Green/White
Violet
Brown/Red
White/Blue
Blue/Red