Drum Maintenance Camshaft Assembly
(PL 2.11)
1.
Remove both the Drum Maintenance Pivot Plate Assembly (see page 8-32).
2.
Remove the Process Drive Gearbox assembly (see page 8-50).
3.
Slide the shaft to the right, free the bushing, and remove the shaft to the right.
4.
Carefully pry the bushing out of the right ground plane.
5.
Rotate the left end of the shaft slightly toward the rear of the printer, lift the shaft
through the slot, and pull it out to the right through the large hole.
Service Manual
s8400-157
8-31