Drum Maintenance Pivot Plate Assembly
(PL 2.10)
1.
Remove the Drum Maintenance Kit Assembly.
2.
Remove both the Right and Left Side Covers (see page 8-5).
3.
Remove the KL-clip on the left end of the Pivot Plate Shaft.
4.
Remove the grounding clip on the right end of the Pivot Plate Shaft.
5.
Remove the Pivot Plate Shaft.
6.
Disconnect the connector from the I/O Board (black/white).
7.
Feed the cable into the printer while sliding the Drum Maintenance Pivot Plate
out the drum maintenance drawer cavity.
8-32
2
3
GREASE
POINTS
Phaser 8400 Color Printer
1
s8400-158