Drum Heater Relay Board - Xerox Phaser 8400 Service Manual

Color printer

Hide thumbs Also See for Phaser 8400:

Table of Contents

Drum Heater Relay Board

This is an AC board, shut off power to the printer and disconnect the power

cord before starting this procedure.

Remove the right side cover (see page 8-5).

Disconnect the three wires to the Drum Heater Relay Board.

Remove the screw securing the Drum Heater Relay Board to the printer.

Remove the Drum Heater Relay Board.

Replacement Note:

Ensure that no wires are routed behind the Drum Heater Relay Board during

reinstallation. Some of these wires carry AC line voltage and a short could

result in AC being shorted to accessible locations.

Phaser 8400 Color Printer