Xerox Phaser 8400 Service Manual page 287

14.
Remove 3 screws and washers from the left side of the Drum Assembly.
15. Remove the Drum Assembly from the chassis by lifting it straight up as shown in
the following figure.
Caution
Never rest the drum on its pulley. Let the pulley hang over the edge of a
surface and place the drum on its feet.
Replacement Notes:
Note
The Transfix Load Arms and the Media Release Blade Carriage Assembly
can be installed on the Drum Assembly either before the Drum is installed in
the printer or after. This procedure installs these components after the Drum
is installed.
Note
After installing the Exit Module, perform the Wiper Alignment (see
page 6-2). The printer may report error code 7,009.4x if the wiper assembly
is misaligned.
1. Gently seat the Drum Assembly into the chassis.
2.
Align the screw holes in the left and right Labyrinth Seals to holes in the chassis
sides.
3.
Install 1 screw at the rear position to hold the left Labyrinth Seal and torque the
screw to 25 in.-lbs.
Service Manual
No washer
s8400-160a
8-35