Xerox Phaser 8400 Service Manual page 129

Menu Map (Continued)
Menu
Exercise Heaters
Menu
Front Panel Display
Service Manual
Tray 3 Motor &
Shafts
Tray 4 Pick Shaft
Tray 4 Lift Motor
Tray 4 Motor &
Shafts
Monitor heaters
Monitor
Temperatures
All Heaters On
All Heaters Off
Toggle Printhead
Heaters
Toggle Preheat
Heater
Toggle Drum
Heater
Toggle Ink Melt
Heaters
Cycle LED
Set display dark
Description
Cycles the motor/shaft repeatedly until
interrupted by a front panel button
press. If not installed generates an
"Option not detected" message.
Cycles the motor/shaft repeatedly until
interrupted by a front panel button
press. If not installed generates an
"Option not detected" message.
Cycles the motor/shaft repeatedly until
interrupted by a front panel button
press. If not installed generates an
"Option not detected" message.
Cycles the motor/shaft repeatedly until
interrupted by a front panel button
press. If not installed generates an
"Option not detected" message.
Allows the heaters to forced to an ON
or OFF condition or to be toggled from
one condition to the other. Also provide
monitoring to observe the resulting
heater power or temperature.
Monitors heater power.
Monitors heater temperature.
Turns all heaters On.
Turns all heaters Off
Toggles printhead heaters to opposite
state.
Toggles preheat heater to opposite
state.
Toggles drum heater to opposite state.
Toggles ink melt heaters to opposite
state.
Exercises the front panel LCD/LED
outputs.
Cycles the LED through a red/Yellow/
Green sequence.
Sets the LCD display dark.
4-9