Table of Contents
Advertisement
VII. PAN/TILT ZOOM CONTROL
PTZ control is available for supported third-party dome cameras. The PTZ option must be
configured for each camera channel. For PTZ setup, refer to Camera Setup> PTZ setup.
The layout of the PTZ interface conforms to the layout of the front of the NVR or the remote
controller. Menu button is the guide anchor position for all other buttons. When in PTZ
interface mode, all buttons are used for the PTZ related operation.
1. P.T.Z. Menu
To activate the Pan/Tilt Control, select the full screen display of the camera you wish
1)
to control.
Then press the [
2)
INDICATOR
Press this button to display "HELP" Menu. Press [OK] Button again, or
[ESC] button to cancel Help Menu.
[OK] [ESC]
Press this button to cancel "PAN/TITL" Operation.
PTZ camera control interface is extended to use all functions. Press this
button again to go to the short-cut menu.
[MENU] Button
To Tilt Up and Down.
To Pan Right and Left.
Zoom In and Out.
] button. A shortcut Menu box pops up, as shown below.
P/T/Z/FOCUS
<Note > Please Refer to the Help Menu for specific
control.
ACTIONS
74
Advertisement
Table of Contents
