Table of Contents
Advertisement
2. Preset & Tour
Button
Set preset position; SPOT OUT on remote controller
a.
Move the PTZ into the desired location.
b.
Press the Preset button.
c.
Custom 1 illuminates.
d.
Set the # for the Preset location.
e.
Press OK to save and exit.
Go to preset position; INFO on remote controller
a.
Press Go to button.
b.
Enter the desired Preset # and press OK.
Start Auto Tour; BACKUP on remote controller
a.
Press Auto Tour Button.
b.
Press the + button and enter the range of Preset and press OK.
2.1 Tour Group
A preset Tour Group allows a camera to move through a programmed sequence of PTZ
presets.
1) Communication settings.
:Configure appropriate model and then select the corresponding baud rate, PTZ
ID (address). Please refer to the PTZ manufacturer's instruction manual for proper
jumper settings to match the protocol settings to the NVR.
Function
76
①
②
③
Advertisement
Table of Contents
