Input Air Connection; Connection For Return Cable - ESAB powercut 700 PT-39 Instruction Manual

US
Recommended sizes for input conductors and line fuses
Input requirement
Volt
230
MAKE SURE THE POWER SOURCE IS SWITCHED OFF BEFORE REMOVING THE
FUSE.
5.3

Input air connection

Connect your air supply to the inlet connection of the filter. Any cylinder of
compressed air or air from a compressor may be used. The air must be free from
polluting particles. A pressure regulator is provided to ensure the correct air flow rate
on the torch. Set the pressure with the knob on the top of the regulator.
5.4

Connection for return cable

Clamp the return cable to the workpiece. Be sure the workpiece is connected to an
approved earth ground with a properly sized ground cable.
bp23aa
Phase Amps
1 41
- 12 -
Input & Gnd Line fuse
conductors
Cu/Awg Amps
8 50
© ESAB AB 2012