Connection Of Torch - ESAB powercut 700 PT-39 Instruction Manual

US
5.5

Connection of torch

The installation must be done by a professional.
A Torch cable receptacle to panel receptacle
B Torch end
C Air hose to quick-connect fitting
The power source is equipped with a quick-disconnect solution for connecting and
disconnecting the torch.
1. Turn off the main switch, disconnect the power cable and the air supply.
2. Open the left side cover by unscrewing 4 screws.
3. Insert the torch end with cable receptacle and air hose through the hole in the
front of the power source.
4. Connect the torch cable receptacle to the panel receptacle and check that the
sockets are correctly orientated.
5. Connect the air hose to the quick-connect fitting.
6. Close the left side cover.
7. Connect the power cable and turn on the main switch.
bp23aa
- 13 -
© ESAB AB 2012