Table of Contents
Advertisement
Explanation
Cannot create Snapshot pair.
Recommended action
(1) Perform the following using Storage Management Software:
[XP P9500/XP7]
1.
1) If Snapshot P.P is not valid, make it valid. (See Table3.3-2)
2.
2) Delete any Snapshot pairs which are not used when the number of Snapshot pairs
has reached the maximum.
3.
3) Delete any V-VOLs which are not used when the number of V-VOLs has reached
the maximum.
4.
4) Delete any host groups which are not used when the number of host groups existing
in the disk array system has reached the maximum.
5.
5)Confirm whether the pool number (Data pool/THP pool/Fast Snap pool number)
specified with the setup file is a pool for the Snapshot pair creation corresponding to
the disk array system.
6.
6)Confirm that a pool for the Snapshot pair creation corresponding to the disk array
system is set, and set if not. Expand the capacity if there is insufficient space for the
data pool..
[XP7]
1.
1) In the case of the virtual DKC which straddles multiple physical DKCs, confirm that
the pool number specified in the configuration file exists in each physical DKC.
2.
2) If the pool of the pool number which was identical with the each physical DKC has
not been set, set the pool.
(2) An error occurred when an operation command was given to a disk array system. See
"About errors attributable to disk array systems" (page
5023
Type
Error
Message
Abort the resync shadowcopy operation: [Message], Error# [Error number]
Explanation
Restore processing was aborted.
Recommended action
(1) Confirm a pair status for restore using Storage Management Software.
(2) An error occurred when an operation command was given to a disk array system. See
"About errors attributable to disk array systems" (page
5025
Type
Error
Message
Deleting shadow copy failed for storage (serial number #). [serial number]
133).
133).
Error messages
79
Advertisement
Table of Contents
