Table of Contents
Advertisement
Explanation
Split pair failed.
Recommended action
An error occurred when an operation command was given to the disk array system.
See
"About errors attributable to disk array systems" (page
E20020B8
Message
--> Configuration file is wrong. Check hivsscmd.log.
Explanation
The setup file has an entry error. Alternatively, the disk array system cannot be connected to.
Recommended action
(1) Confirm that the entries in the configuration file are correct.
(2) Confirm the IP address or serial number of the disk array system using Storage
Management Software, and set them in the proper format in the setup file (See Subsection
3.2.1).
(3) Confirm that the LAN cables are connected properly.
(4) Confirm that the Password Protection function of the disk array system is set to disabled.
(5) Delete utlprm.inf, utlprm2.inf, and utlprm3.inf. Then re-execute the disk array system
registration with the GUI tool.
E20020B9
Message
Error: No devices found. Please check whether the controller IP is added in the config file.
Explanation
Could not connect to the disk array system.
Recommended action
(1) Confirm the IP address of the disk array system using Storage Management Software,
and enter the IP address of the disk array system in the proper format in the setup file (See
Subsection 3.2.1).
(2) Confirm that the LAN cables are connected properly.
E20020C0
Message
Error: Unable to find/connect to the storage device. Please check whether the controller IP is
added in the config file.
Explanation
There is no disk array system corresponding to the IP address specified in the setup file.
Alternatively, the disk array system of the specified IP address cannot be connected to.
133).
Error messages 123
Advertisement
Table of Contents
