E100014C - HP XP User Manual

Explanation
An Error was detected by RAID Manager command.
Recommended action
(1) Confirm that hiRaidcomX.config exists in the installation folder of VSS Provider.
(2) Confirm that the contents of hiRaidcomX.config are correct.
(3) Confirm that RAID Manager is installed.
(4) See the command error messages in Table 9-4 of the RAID Manager User's Guide. Error
IDs correspond to the values in the table.
(5) Confirm that the FC cable has been connected correctly.
(6) Confirm that HORCM has been activated.
(7) For the characters and the maximum number of input characters for a user name and
password, see RAID Manager command reference.
(8)In case of using VMware Guest to Guest Backup (FC) function, confirm that it is not falling
under the restrictions of instance number of RAID Manager. See Table 2.5.2-4.
(9) If the Ext Stor configuration is used by the multiple physical DKCs or in the case of the
HA configuration, place a command device in the meta_resource (RSG#0) of each physical
DKC. Also, map it onto the host group of the target server and command devices of all
physical DKCs must be recognized.
(10) An error occurred in the RAID Manager interface. For the occurred error code and SSB
code, check the RAID Manager User`s Guide for appropriate action. If the problem has not
been solved with the action stated in the related documents, contact Hewlett Packard
Enterprise Support Center.

E100014C

Message
Failed to get HBA Adapter attributes. Error: [Error code].
Explanation
Acquisition of the HBA adapter information failed.
Recommended action
In the case of an iSCSI environment, ignore this error.
In an FC environment, confirm whether HBA is recognized correctly.
E100014F
Message
Failed to get an iSCSI initiator node name. Error: [Error code].
Explanation
Microsoft iSCSI Initiator Service stops.
Recommended action
In the case of an FC environment, ignore this error.
In an iSCSI environment, start Microsoft iSCSI Initiator Service by service of the management
tool.
Error messages 101