Table of Contents
Advertisement
Explanation
Failed to get storage information
Recommended action
(1) Confirm the IP address or serial number of the disk array system using Storage
Management Software, and set them in the proper format in the setup file (See subsection
3.2.1).
(2) Confirm that the LAN cables are connected properly.
E200203D
Message
Error: Unable to get information for P-Vol.
Explanation
Cannot get information for a P-VOL.
Recommended action
(1) The specified P-VOL may not exist in the disk array system. Confirm it using Storage
Management Software.
(2) An error occurred when an operation command was given to the disk array system.
See
"About errors attributable to disk array systems" (page
E200203E
Message
Error: Unable to find the CM volume on this server. Please configure a CM volume and expose
it to this server.
Explanation
Command device is not set.
Recommended action
Map the command device using Storage Management Software.
E200203F
Message
There are no S-Vols configured for the P-Vol LU: [P-VOL LU#].
Explanation
A Business Copy pair is not configured.
Recommended action
The specified P-VOL may not been mapped to the VSS installation server (application server).
Map it by using Storage Management Software.
E2002040
Message
The S-Vols are not ready for a backup.
114
Troubleshooting
133).
Advertisement
Table of Contents
