Changing Over Door Hinges; Fitting Dimensions; Installing In A Kitchen Unit Ero3298; Installing In A Kitchen Unit Ik 319 - Electrolux ERO 3298 Operating Instructions Manual

Changing over door hinges

• Loosen attachment screws ➊.
• Remove the door.
• Lift off covers ➌.
• Replace all attachment screws ➊ on the other side and screw
in a little way.
• Undo door attachment screws ➋ and transfer the hinges to the
diagonally opposite corner.
• Suspend the appliance doors on the screws inserted previously
➊ and tighten the screws.
• Cover all open attachment holes with covers ➌.

Fitting dimensions

Align housing unit with spirit level and set square using shims if
necessary. The shelves and sides of the housing unit must be
perpendicular to each other.
At least 200 cm² is required for ventilation at the bottom and
around the housing unit.
Fitting dimensions (mm):
ERO 3298
24
A B
560-570 550
IK 319
550 605

Installing in a kitchen unit ERO3298

• Pull off film and stick sealing
strip to handle side of
bp
applince, shortening to the
height of the recess if neces-
sary.
• Note the thickness of the unit
walls:
For 16 mm unit wall (568 mm
recess):
- Clip spacers
bq
the hinges.
- Slide appliance into the re-
cess until the spacers make
contact with the side of the
units.
• Screw plastic bracket onto the han-
dle side of the appliance with M5
screws.

Installing in a kitchen unit IK 319

• Slide the attachment element
into the rail underneath the
appliance on the handle side
on the left or right, depending
on which side the handle is.
Screw into place with the 3.5 x
11 countersunk screw.
C
559
545

Changing the compartment door.

• Remove plugs ➊.
• Unscrew lash ➋. Unscrew compartment door with bearings ➌,
turn through 180° and reassemble on the other side.
• Cover holes with plugs ➊.
and onto
br