Table of Contents
Advertisement
Instructions to assemble the refrigerator
door to the kitchen unit door
Position the runners (C) at the top and bottom of the
inside of the kitchen unit as shown in Fig. 5 and mark
the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
C
D135
Open both the appliance door and that of the kitchen
unit to approx. 90 .
Place the little plates over the runners. Hold the doors
of the appliance and the unit together and mark the
holes.
8mm
D415
Remove the little plates and make the holes with a di-
am. of 3,2 mm. Replace the little plates over the run-
ners and screw in the screws provided (3.5x16 mm).
For the alignment of the kitchen unit door, if neces-
sary, use the clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Fig. 5
D416
Reversibility of the freezer door
When changing the hinges of the refrigerator door
from right to left, it is also advisable to change the
opening side of the freezer door.
Please take the following steps:
1. Remove the door lower hinge.
Fig. 6
2. Remove the freezer door and take off the upper
hinge.
3. Unscrew the catch and fix it on the opposite side.
4. Fix the upper hinge.
5. Mount the freezer door on the left side and fix the
lower hinge.
180°
Fig. 7
(Fig. 8)
Fig. 8
15
Advertisement
Table of Contents
