Table of Contents
Advertisement
2.6.7 Temporary Device Access Code Programming
This programming sequence programs up to 10 temporary device access codes with a beginning and ending date and any
time zone restrictions that may need to be applied.
1. Press
2. Enter the device type (0 = card, 1 = transmitter, 2 = keypad, 3 = other), then press
3. Choose and enter a five-digit access code, then press
4. Enter the beginning month (01-12) and day (01-31), then press
5. Enter the ending month (01-12) and day (01-31), then press
6. Enter a minimum of 1, and a maximum of 4 time zones (valid time zones are 0 through 6) that you
want to apply to this access code, then press
Time zone 0 - Always deny access.
Time zone 1 - Allows 24/7 access for relay 1 and any additional relays.
Time zone 2 - Allows 24/7 access for relay 2 and any additional relays.
Time zones 3, 4, 5 and 6 - Are time zones that have been programmed in 2.7.6.
7. Enter 0
8. Repeat steps 2 through 5 to program additional access codes (Time zone restricted).
9. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
If you make a mistake while programming steps, press "0 #" together and start at step 1 again.
2.6.8 Delete a Temporary Device Access Code
This programming sequence deletes individual device access codes that have been programmed into the system.
1. Press
2. Enter the device type (0 = card, 1 = transmitter, 2 = keypad, 3 = other), then press
3. Enter the five-digit temporary device access code to be deleted, then press
4. Repeat steps 2 and 3 to delete additional existing temporary device access codes.
5. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.6.9 Delete All Temporary Device Access Codes
This programming sequence deletes all (10) temporary device access codes that have been programmed into the system.
WARNING: Once started, Once started, all temporary access codes will be erased.
1. Press
2. Press 9 9 9 9, then press
3. The programming sequence will end itself automatically. [beeeeeep]
1810-162-A-6-16
7 3 and enter the MASTER CODE. [
*
for momentary relay activation or enter 1
*
7 4 and enter the MASTER CODE. [
*
7 5 and enter the MASTER CODE. [
*
. [ 9 9 9 9 (beep)]
*
7 3 _ _ _ _ (beep)]
*
. [ _ _ _ _ _
(beep)]
*
*
. [ _ _ _ _
*
. [ _ _ _ _
*
. [ _ _ _ _
(beep)]
*
*
to hold open (latch) the relay. [ _
*
7 4 _ _ _ _ (beep)]
*
7 5 _ _ _ _ (beep)]
*
. [ _
(beep)]
*
*
(beep)]
*
(beep)]
*
(beep)]
*
. [ _
(beep)]
*
*
. [ _ _ _ _ _
(beep)]
*
*
43
Advertisement
Chapters
Table of Contents
Troubleshooting
