2.4 System Parameters Programming
IMPORTANT!
We strongly suggest that you read these programming instructions in their entirety
before beginning any manual programming of the Access Plus system.
The programming table on the next page provides a quick reference to:
Programming from the System Keypad
1 1
2 2
3 3
NAME
CODE
Adams J
1
Bernard E
9
4 4
5 5
6 6
Brown L
5
Davis T
2
Hodges S
4
7 7
8 8
9 9
Miller J
6
Smith K
8
Thomas W
3
0 0
Zimmer R
7
Programming from a Touch-Tone Telephone
1810-162-A-6-16
Follow the programming instructions as described in each section of this manual.
IMPORTANT
The system will prompt you with short tones (beep) when programming steps have
been correctly keyed in and with a long tone (beeeeeep) when all of the programming steps have
been successfully completed in the sequence.
If you make a mistake while programming steps, press "0 #" together and start at step 1 again.
Follow these steps when programming the Access Plus system from a Touch-Tone
Telephone.
IMPORTANT
The unit must be programmed to answer incoming calls, section 2.4.9.
1. Call the resident telephone number. The unit will answer with a short beep after the programmed
number of rings.
2. Follow the programming instructions as described in each section of this manual. The system will
prompt you with short (beep) tones when programming steps have been followed correctly.
3. When complete, hang up. You cannot use 0# pressed together to end programming steps from a
touch-tone telephone. Wait 30 seconds before calling back to program another feature.
35