Single Or Multiple Systems; Single Or Double Ring; Number Of Resident Phone Rings Before Unit Hangs Up; Single Or Double Ring (1816 Interface Only) - Intertek 1802 Installation & Owner's Manual

2.4.2 Single or Multiple Systems

Factory setting is 1 (Single System).
Set for single if the unit is the only unit connected to the phone line, or set to multiple if more than one unit is connected to
the phone line.
If you make a mistake while programming steps, press "0 #" together and start at step 1 again.

2.4.4 Single or Double Ring

The Access Plus unit can be used in both an AUTO-DIALER and/or 1816 Access Plus telephone INTERFACE configuration.
When used as an AUTO-DIALER, the double ring programming has NO affect on the ring
company and it will always be the standard single ring no matter how the ring is programmed in the Access Plus unit.
In the telephone INTERFACE mode connected to the 1816 Access Plus telephone Interface module, the double ring
provides a unique ring so that a call from the Access Plus unit is easily identified by the resident.
In the telephone interface mode connected to the 1816 AP module, the double ring provides a unique ring so that a call
from the Access Plus unit is easily identified by the resident.
Factory setting is 1 (Double Ring).

2.4.5 Number of Resident Phone Rings Before Unit Hangs Up

This programming step is only used if the Access Plus unit is connected with the 1816 Access Plus telephone interface.
This programming step is not applicable when the Access Plus unit is used as an auto-dialer.
This programming sequence sets the number of unanswered rings to the resident's phone before the Access Plus unit
hangs up.
Factory setting is 05 (5 Rings).
1810-162-A-6-16
1. Press 6 1 and enter the MASTER CODE. [
*
2. Press 1 for a single system OR press 0
*
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
1. Press 6 3 and enter the MASTER CODE. [
*
2. Press 1 for a double ring OR press 0
*
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
1. Press 6 4 and enter the MASTER CODE. [
*
2. Enter the number of rings before unit hangs up (01-99), then press
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
6 1 _ _ _ _ (beep)]
*
for multiple systems. [ _
*
6 3 _ _ _ _ (beep)]
*
for a single ring. [ _ (beep)]
* *
6 4 _ _ _ _ (beep)]
*
(beep)]
*
– this is controlled by the phone
. [ _ _ (beep)]
* *
37