Delete A Phone Number From Directory Codes; Delete All Phone Numbers From Directory Codes; Delete All Phone Numbers From Directory Codes; Access Codes To Operate Access Control Devices - Intertek 1802 Installation & Owner's Manual

2.5.2 Delete a Phone Number from Directory Codes 24 – 50
This programming sequence deletes individual directory code dial-out phone numbers from the system memory.
WARNING: once deleted, this CANNOT be undone.
2.5.3 Delete ALL Phone Numbers from Directory Codes 24 – 50
This programming sequence will delete ALL directory code dial-out phone numbers from the system memory.
WARNING: once started, all phone numbers will be erased. This CANNOT be undone.

2.6 Access Codes to Operate Access Control Devices

Note: All access codes are five (5) digits in length.
2.6.1 "Simple" Access Code Programming (Relays 1&2: 24/7 Operation)
This programming sequence programs "simple" access codes used on the Access Plus unit keypad into the system
memory. "Simple" access codes CANNOT be time zone restricted; they can ONLY be assigned to operate the internal
Relay 1 or Relay 2 on a 24/7 basis using the relay strike time programmed in section 2.4.7. If you require access codes to
be "time zone restricted", use the programming sequence in 2.6.4.
Note: Up to 50 access codes can be programmed into the system. This 50 includes "simple" access codes programmed in
2.6.1 AND "time zone restricted" access codes programmed in 2.6.4. For example, if 10 "simple" access codes are
programmed in 2.6.1, then only 40 "time zone restricted" access codes can be programmed in 2.6.4.
If you make a mistake while programming steps, press "0 #" together and start at step 1 again.

2.6.2 Number of RS-485 Devices

Factory setting is 0 (No Devices Connected).
This programming sequence sets how many remote RS-485 devices are connected to the Access Plus unit.
1810-162-A-6-16
1. Press 4 2 and enter the MASTER CODE. [
*
2. Enter a two-digit directory code (24-50) of the phone number you want to delete, then press
[ _ _ (beep)]
*
3. Repeat step 2 to delete additional existing phone numbers.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
1. Press 4 3 and enter the MASTER CODE. [
*
2. Press 9 9 9 9, then press
3. The programming sequence will end itself automatically. [beeeeeep]
1. Press 0 2 and enter the MASTER CODE. [
*
2. Press 1 for relay 1 OR Press 2 for relay 2, then press
3. Choose and enter a five-digit "simple" access code, then press
4. Repeat steps 2 and 3 to enter additional "simple" access codes.
5. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
1. Press 0 9 and enter the MASTER CODE. [
*
2. Enter a single-digit number of devices connected (0-6), then press
Entering a 0 in this step will disable RS-485 communication.
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
4 2 _ _ _ _ (beep)]
*
4 3 _ _ _ _ (beep)]
*
. [ 9 9 9 9 (beep)]
*
0 2 _ _ _ _ (beep)]
*
0 9 _ _ _ _ (beep)]
*
. [ _ (beep)]
* *
. [ _ _ _ _ _ (beep)]
* *
. [ _ (beep)]
* *
.
*
41