Answer Incoming Call On X Rings; Call Waiting On/Off; Turn Speaker On / Control Relay From Phone Call - Intertek 1802 Installation & Owner's Manual

2.4.9 Answer Incoming Call on X Rings

Factory setting is 06 (6 Rings).
This programming section sets the number of rings that the unit will allow to pass through the system before it picks up
the call. The number of rings to answer can be set from 1 to 99 rings and must be entered as a two-digit number.
For example, if you want the unit to answer the call after the sixth ring, enter 0 6
2, this will prevent (disable) the unit from answering incoming calls to it.

2.4.11 Call Waiting ON/OFF

This programming step is ONLY used if the Access Plus unit is connected with the 1816 Access Plus telephone
interface. This programming step is not applicable when the Access Plus unit is used as an auto-dialer.
These steps will turn the Call Waiting feature either ON or OFF. The call waiting feature will allow the resident to place an
outside call on hold when a visitor places a call from the Access Plus unit. Once communication with the visitor is estab-
lished, access can be granted or denied. If access is granted (press the tone open number to open the door or gate), the
unit will automatically switch the call back to the outside call. If the resident wants to deny access, they simply press the #
key to switch back to the outside call.
Factory setting is 1 (Call Waiting On).

2.4.12 Turn Speaker On / Control Relay from Phone Call

This command allows you to call the unit from a touch-tone phone and turn on the speaker at the unit to enable two-way
voice communication and will allow relay control – all "Tone Open Numbers" that are programmed (2.4.8).
1810-162-A-6-16
1. Press 1 8 and enter the MASTER CODE. [
*
2. Enter the number of rings (01-99), then press
(enter 00 in this step to disable this feature)
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
1. Press 2 0 and enter the MASTER CODE. [
*
2. Press 1 to turn Call Waiting ON OR press 0
*
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
1. Call the resident's phone number. After the programmed number of rings (2.4.9) the unit will answer
with a tone.
2. Press 1 6 and enter the MASTER CODE. [
*
If you use a "tone open number" during the call to activate a relay, the unit will automatically hang up
after the "tone open number" is used. Only one activation number will function per phone call.
Example: If you call and want to "Hold Open" the relay, you will have to call back to "Deactivate" it later.
3. Hang up when your conversation is completed if NOT using a "tone open number".
in step 2. If you program 0 0
*
1 8 _ _ _ _ (beep)]
*
. [ _ _ (beep)]
* *
2 0 _ _ _ _ (beep)]
*
to turn Call Waiting OFF. [ _
*
1 6 _ _ _ _ (beep)]
*
in step
*
(beep)]
*
39