Settings Display - Siemens 7SR224 Technical Manual

7SR224 Argus Settings, Configuration & Instruments
1.3

Settings Display

The Settings Mode is reached by pressing the READ DOWN ▼ button from the relay identifier screen.
Once the Settings Mode title screen has been located pressing the READ DOWN ▼ button takes the user into
the Settings mode sub-menus.
Each sub-menu contains the programmable settings of the relay in separate logical groups. The sub menus are
accessed by pressing the TEST/RESET► button. Pressing the READ DOWN ▼ button will scroll through the
settings, after the last setting in each sub menu is reached the next sub menu will be displayed. If a particular sub
menu is not required to be viewed then pressing READ DOWN▼ will move directly to the next one in the list.
While a setting is being displayed on the screen the ENTER button can be pressed to edit the setting value. If the
relay is setting password protected the user will be asked to enter the password. If an incorrect password is
entered editing will not be permitted. All screens can be viewed even if the password is not known.
While a setting is being edited flashing characters indicate the edit field. Pressing the READ UP ▲ or READ
DOWN ▼ buttons will display the valid field values. If these buttons are pressed and held, the rate of scrolling will
increase.
Once editing is complete pressing the ENTER button stores the new setting into the non-volatile memory. The
setting change is effective immediately unless any protection element is operating, in which case the change
becomes effective when no elements are operating.
NB: The Settings Display may vary between software versions. Please see the appendices to this section of the
manual for relevant software version.
©2010 Siemens Protection Devices Limited Chapter 2 Page 7 of 13