Debug Mode - Avaya H.323 9608 Installing And Maintaining

each have a color display, and contrast adjustment is not applicable. Fifteen contrast levels
are available.
Procedure
1. When you select CONT from the Craft Local Procedure Screen, the deskphone
2. To change the setting, press the Right or Left navigation arrow to navigate through
3. If more than one button module is attached, scroll down to that line, for example, to
4. Press Save to store the new contrast settings and redisplay the Craft Local

Debug mode

About this task
You can use the debug mode to send all your debug data in a file, nnn_report.gz where you
replace nnn by the deskphone extension as specified by the user during registration.
Note:
The DEBUG option is available for use only if you change the default password to the craft
menu through the PROCPSWD parameter.
The new value of the PROCPSWD parameter must be 4 to 7 numeric digits, "0000" through
"9999999". However if value of PROCPSWD is less than 4 digits after you install Release
6.2.4 or later, the value will be changed back to the default value of 27238.
Procedure
1. Scroll and select DEBUG from the Craft Local Procedure Screen. Press Start. The
Installing and Maintaining Avaya IP Deskphone H.323 9608, 9611G, 9621G, and 9641G
prompts you to use the Right and Left navigation arrows to change the contrast for
button module shown as Module: 1 or the contrast for the deskphone shown as
Phone: contrast.
the settings.
By default, the contrast button is set to the middle of the contrast setting.
As you press the navigation arrow, the next higher or lower contrast level is selected
and displayed as the setting.
Module: 2 and repeat Step 2 to change the contrast.
Procedure screen.
deskphone displays, the following text:
Setting
Serial Port
Options available
Adjunct/CLI
Debug mode
August 2013 53