Flexiblelom - HP ProLiant WS460c Gen9 Maintenance And Service Manual

graphics expansion control cable is installed, the long cable will be connected in the lower
connector on the riser.
To replace the component, reverse the removal procedure.

FlexibleLOM

To remove the component:
Power down the graphics server blade (on page 25).
1.
Remove the graphics server blade
2.
Place the graphics server blade on a flat, level work surface.
3.
Remove the access panel
4.
Remove the mezzanine assembly
5.
Use the FlexibleLOM handle to remove the FlexibleLOM from the system board.
6.
To replace the component, reverse the removal procedure.
("Remove the graphics
("Access panel (graphics server
("Mezzanine assembly" on page 34).
blade" on page 26).
blade)" on page 31).
Removal and replacement procedures 49