Mezzanine Board Options; Mezzanine Options - HP ProLiant WS460c Gen9 Maintenance And Service Manual

Install the access panel.
3.
Install the graphics server blade.
4.

Mezzanine board options

Mezzanine options are installed only on the Mezzanine 1 and Mezzanine 2 connectors found on the
system board of the single-width blade or host-side of the double-width blade. The procedure for these
options is not the same procedure for installing options on the expansion-side on the double width-
blade.
Be sure that the type of mezzanine card being installed is supported on the mezzanine connector being
used. To locate the mezzanine connectors, see "System board components (on page 91)." For
information about the mezzanine connectors, see "Mezzanine connector definitions (on page 92)."
This graphics server blade supports multiple mezzanine options. For more information, see the product
QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).

Mezzanine options

To remove the component:
Power down the graphics server blade (on page 25).
1.
Remove the graphics server blade
2.
Place the graphics server blade on a flat, level work surface.
3.
Remove the access panel
4.
Remove the mezzanine assembly
5.
Remove the mezzanine card from the mezzanine assembly.
6.
("Remove the graphics
("Access panel (graphics server
("Mezzanine assembly" on page 34).
blade" on page 26).
blade)" on page 31).
Removal and replacement procedures 35