Drive Backplane - HP ProLiant WS460c Gen9 Maintenance And Service Manual

Remove the front panel/drive cage assembly.
12.
To replace the component, reverse the removal procedure.

Drive backplane

To remove the component:
Power down the graphics server blade (on page 25).
1.
Remove the graphics server blade
2.
Place the graphics server blade on a flat, level work surface.
3.
Remove the access panel
4.
Remove all drives ("Drive" on page 33).
5.
Remove all drive blanks
6.
CAUTION: Remove all drives and drive blanks before removing the drive backplane.
Do one of the following:
7.
Remove the storage controller
o
Disconnect the direct connect SATA cable
o
Remove the internal USB drive, if installed. To locate the internal USB connector, see "System
8.
board components (on page 91)."
Remove all DIMM baffles
9.
Remove the front panel/drive cage assembly
10.
("Remove the graphics
("Access panel (graphics server
("Drive blank" on page 32).
("Storage controller" on page 50)
("Direct connect SATA
("DIMM baffles" on page 51).
("Front panel/drive cage
blade" on page 26).
blade)" on page 31).
cabling" on page 80).
assembly" on page 54).
Removal and replacement procedures 55