Pcie Mezzanine Pass-Through; Pcie Mezzanine Pass-Through Brackets - HP ProLiant WS460c Gen9 Maintenance And Service Manual

Press down firmly on the mezzanine assembly handles, and then close the mezzanine assembly
4.
latch.
Install the access panel.
5.

PCIe mezzanine pass-through

To remove the component:
Power down the graphics server blade (on page 25).
1.
Remove the graphics server blade
2.
Place the graphics server blade on a flat, level work surface.
3.
Remove the expansion blade access panel
4.
Remove the expansion blade front bezel
5.
29).
Remove the foam gasket (on page 27).
6.
Disconnect the power cable from the expander power board and the PCI graphics option.
7.
Remove the graphics expansion control cable.
8.
Remove the retaining block (on page 29).
9.
Remove the expansion blade PCIe card cage (on page 28).
10.
Remove the expansion blade from the host side (on page 30).
11.
Remove the mezzanine assembly
12.
Remove the PCIe mezzanine pass-through board
13.
To replace the component, reverse the removal procedure.

PCIe mezzanine pass-through brackets

The graphics server blade supports up to two PCIe mezzanine pass-through boards. If one PCIe
mezzanine pass-through board is installed, install the clear single PCIe mezzanine-pass through
bracket on the PCIe mezzanine pass-through board. If two PCIe mezzanine pass-through boards is
installed, install the black dual PCIe mezzanine pass-through bracket.
To remove the component:
Power down the graphics server blade (on page 25).
1.
("Remove the graphics
("Expansion blade access
("Remove the expansion module front
("Mezzanine assembly" on page 34).
("Mezzanine
blade" on page 26).
panel" on page 31).
bezel" on page
options" on page 35).
Removal and replacement procedures 37