Heatsink - HP ProLiant WS460c Gen9 Maintenance And Service Manual

Remove the battery.
5.
IMPORTANT: Replacing the system board battery resets the system ROM to its default
configuration. After replacing the battery, reconfigure the system through UEFI System
Utilities.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

Heatsink

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
To remove the component:
Power down the graphics server blade (on page 25).
1.
Remove the graphics server blade
2.
Place the graphics server blade on a flat, level work surface.
3.
Remove the access panel
4.
Do one of the following:
5.
Remove the storage controller
o
Disconnect the direct connect SATA cable
o
NOTE: Only remove the storage controller if the processor 2 heatsink is being removed.
Remove the internal USB drive, if installed. To locate the internal USB connector, see "System
6.
board components (on page 91)."
Remove all DIMM baffles
7.
("Remove the graphics
("Access panel (graphics server
("Storage controller" on page 50)
("Direct connect SATA
("DIMM baffles" on page 51).
blade" on page 26).
blade)" on page 31).
cabling" on page 80).
Removal and replacement procedures 57