Front Panel Leds And Buttons (Graphics Server Blade) - HP ProLiant WS460c Gen9 Maintenance And Service Manual

Front panel LEDs and buttons (graphics server
blade)
Item Description
Health status LED
1
bar*
Power On/Standby
2
button and system
power LED*
UID button/LED*
3
NIC activity LED*
4
*When all four LEDs described in this table flash simultaneously, a power fault has occurred. For more information,
see "Front panel LED power fault codes (on page 88)."
**Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the power button cable is disconnected.
Status
Solid Green = Normal (System is powered on)
Flashing Green = Power On/Standby button service is being initialized
Flashing Amber = Degraded condition
Flashing Red = Critical condition
Off = Normal (System is in standby)
Solid green = System on
Flashing green (1 Hz/cycle per sec) = Performing power on sequence
Solid amber = System in standby
Off = No power present**
Solid blue = Activated
Flashing blue:
•
1 Hz/cycle per sec = Remote management or firmware upgrade in
progress
•
4 Hz/cycle per sec = iLO manual reboot sequence initiated
•
8 Hz/cycle per sec = iLO manual reboot sequence in progress
Off = Deactivated
Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network active
Off = No network activity
Component identification 87