Ip Codec Set; Related Topics - Avaya G450 Configuration Manual

Related topics:
IP codec set: page 2
IP codec set: page 3
IP codec set: page 2
You can configure the following capabilities on the codec set:
• Enable or disable Direct-IP Multimedia for videophone transmissions.
• Enable or disable endpoints in the assigned network region to send fax, modem, or TTY
calls over IP trunks.
• Define the mode that the system uses to route the fax, modem, or TTY calls.
• Determine whether redundancy must be added to the transmission for higher reliability
and quality.
You must assign these capabilities to the codec set, and assign the codec set to a network
region for endpoints in that region to be able to use the capabilities established on this
screen.
Using V.150.1, you can configure fax and modem so that both use a relay mode together in
an IP codec set. You can set the FAX Mode field to t.38-standard for fax calls to use t.38.
However, modem calls use V.150.1.
Note:
Transporting modem signals over IP between Avaya Communication Manager systems and
media gateways is a proprietary implementation. The selection of the V.150.1 Modem Relay
codec choice is not proprietary. For modem transport interoperability with third-party
gateways, v150mr is the recommended mode of operation.

Related topics:

Allow Direct-IP Multimedia
Clear-channel Mode
FAX Mode
Maximum Bandwidth Per Call for Direct-IP Multimedia (units)
Maximum Bandwidth Per Call for Direct-IP Multimedia (value)
Maximum Call Rate for Priority Direct-IP Multimedia
Maximum Call Rate for Direct-IP Multimedia
Modem Mode
Packet Size
Redundancy
TDD/TTY Mode
Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
on page 31
on page 35
on page 32
on page 32
on page 32
on page 34
on page 34
on page 34
on page 35
on page 33
on page 33
on page 33
on page 33

IP codec set

May 2014 31