Chapter 5: Configuring V.150.1 In Communication Manager; Configuring V.150.1 - Avaya G450 Configuration Manual

Chapter 5: Configuring V.150.1 in

Configuring V.150.1

Before you begin
V.150.1 is supported by MP160 Media Processor modules installed in G450. To provide
flexibility in the installation sequence, you can configure Communication Manager Gateway
features before the hardware is installed in the gateway.
V.150.1 is supported by MP120 Media Processor modules installed in G430.
Procedure
1. Access the Communication Manager administrative SAT interface.
2. On the SAT terminal, enter change signaling-group n , where n is the
3. Access page 1.
4. In the DTMF over IP field, type rtp-payload.
5. At the SAT enter change system-parameters ip-options to open the
6. Access page 2.
7. In the Intra-System IP DTMF Transmission Mode field, type rtp-payload.
8. At the SAT enter change ip-codec-set [ n ] to open the change ip-codec-set
9. Access Page 2.
Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
Communication Manager
To open a connection directly to the SAT application in the MGC, add sat to the
command.
For example:
Gxxx-001(super)# session mgc sat
signaling group number
The system opens the change signaling group screen.
system-parameters ip-options screen.
screen.
n is the codec set number (1–7).
For example:
change ip-codec-set 1
IP Codec Set
Page 2 of 2
May 2014 29