Chapter 4: Installing The Mp120 Voip Module; Adding And Removing The Mp120 Voip Module - Avaya G450 Configuration Manual

Chapter 4: Installing the MP120 VOIP

Adding and removing the MP120 VOIP module

About this task
G430 v1 has one on-board VoIP module providing 25 VoIP channels for G.711 and G.726 and
20 channels for G.729, and an additional slot for the optional insertion of an MP10, MP20,
MP80, or MP120 VoIP module. If an MP120 is installed on G430 v1, the on-board VOIP module
is disabled. G430 v2 has no on-board VOIP module.
Note:
The MP120 is capable of supporting new media services such as V.150.1. In the past, all
DSP cards were capable of supporting all codec types, albeit with various performance
differences in terms of point costs. However, the V.150.1 protocol is not supported on the
older DAR cards.
G430 supports a maximum of 120 channels. If an MP120 is installed on a G430 v1, the on-
board VoIP module will be disabled.
The field replaceable VoIP module slot is located on the G430 main board. You must remove
the G430 cover to insert or remove a VoIP module.
Procedure
1.
2.
3.
4.
Related topics:
Removing the G430 cover
Inserting a VoIP module
Removing a VoIP module
Replacing the G430 cover
Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
module
Removing the G430 cover
Inserting a VoIP module
Removing a VoIP module
module into an empty slot.
Replacing the G430 cover
on page 22
on page 24
on page 26
on page 26
on page 22
on page 24
on page 26 — Skip this step if you are inserting a
on page 26
May 2014 21