Removing A Voip Module; Replacing The G430 Cover - Avaya G450 Configuration Manual

Installing the MP120 VOIP module

Removing a VoIP module

About this task
Electrostatic alert:
Hold the module only by its edges to avoid damage from static electricity. Do not touch the
top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-static
bag.
Caution:
The connector pins can be bent or damaged if the module is handled roughly, or if misaligned
and then forced into position.
Procedure
1. Locate the VoIP module slot (see
2. Unscrew the locking screw attaching the VoIP module to the motherboard (see
3. Open the latches on both sides of the module slot.
4. Pull out the module.

Replacing the G430 cover

About this task
Electrostatic alert:
Do not touch any components on the printed circuit board.
Procedure
1. Place the G430 cover back on the unit.
2. Screw in the 8 cover screws you previously removed.
26 Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
figure on page 24).
The module lifts up.
Hold the module only at the edges.
Their locations are indicated by small arrows etched into the cover:
• One screw on the top (see
• Four screws on the right side (see
Comments? infodev@avaya.com
the figure on page 24).
the figure on page 22).
the figure on page 22).
the
May 2014