SecurityPhone.book 24 ページ 2004年7月21日 水曜日 午後6時58分
Device Commands
If some devices are set up for your system, you can activate or deactivate certain
lights or other devices using the Device Commands menu.
Confirm with your installer for devices set up for your system.
Refer to "Using Device Commands" on page 27 in the 3000EN Security Systems
User's Guide.
To activate/deactivate devices
Base Unit
Press [ADT].
1
Scroll to "OTHER FUNCTIONS" by pressing [d]
2
or [B], then press [g].
Scroll to "DEVICE COMMANDS" by pressing [d]
3
or [B], then press [g].
4
To activate devices, press [g] at "ACTIVATE
DEVICE".
To deactivate devices, scroll to "DEACTIV.
DEVICE" by pressing [d] or [B], then press
[g].
Enter your security code.
5
Enter the desired device number.
6
(Ex. To select device number 5, enter "05".)
Press [g] (ENTER).
7
• If a confirmation tone (one beep) is not heard, you
entered the wrong security code in step 5 or wrong
device number in step 6. The setting is not saved.
Try again from step 4.
8
Press [STOP] to go to the standby mode
Handset
: Press the soft key (
the cordless handset. Press the soft key (
the standby mode.
24
g
g
g
g
ENTER CODE
ENTER DEVICE #
Example
ENTER DEVICE #
), and follow steps 2 to 6 above, using
ADT
), then press [OFF] to go to
OK
OTHER FUNCTIONS
DEVICE COMMANDS
ACTIVATE DEVICE
OR
DEACTIV. DEVICE
----
--
05
=ENTER
READY
g