Table of Contents
Advertisement
SecurityPhone.book 34 ページ ２００４年７月２１日 水曜日 午後６時５８分
Security Codes & Authority Levels
Pager
If the Pager setting is turned on, the phone can automatically send a message to a
pager, when the system is armed or disarmed by the programmed user code. The
factory preset is ON.
Refer to "Pager On/Off" on page 31 in the 3000EN Security Systems User's Guide.
Make sure all perimeter doors and windows are closed and
displayed.
While the security system is armed, you can not turn on this function. To turn
on, disarm the security system (p. 12).
Base Unit
Press [ADT].
1
2
Scroll to "OTHER FUNCTIONS" by pressing [d]
or [B], then press [g].
Scroll to "USER CODES" by pressing [d] or [B],
3
then press [g].
Scroll to "PAGER ON/OFF" by pressing [d] or
4
[B], then press [g].
Enter your security code.
5
Enter the user number of 2 digits, then press
6
[g] (ENTER).
(Ex. To select user number 8, enter "08".)
7
Select "Off" or "On" by pressing [d] or [B].
Press [g] (ENTER).
8
• If a confirmation tone (one beep) is not heard, you
entered the wrong security code in step 5 or wrong
user number in step 6. The setting is not saved.
Try again from step 4.
9
Press [STOP] to go to the standby mode.
34
is
READY
OTHER FUNCTIONS
g
USER CODES
g
PAGER ON/OFF
g
ENTER CODE
----
Enter User #
-,-
Example
Enter User #
0,8
=ENTER
READY
g
Pager On/Off
:On
=ENTER
READY
g
Advertisement
Chapters
Table of Contents
