Table of Contents
Advertisement
SecurityPhone.book 9 ページ ２００４年７月２１日 水曜日 午後６時５８分
Setting the Stay mode
When you want to arm the system while persons stay inside, select this mode.
When you set the Stay mode,
— the perimeter zones, such as protected windows and doors, are armed
— interior sensors are left disarmed
— exit delay begins so that you can leave through the exit/entry door, and
— if the protected perimeter windows and doors are opened, an alarm sounds
immediately.
Base Unit
Press [ADT].
1
Press [g] at "ARM".
2
Press [g] at "STAY".
3
• The armed STAY message is displayed.
Press [STOP] to go to the standby mode.
4
Handset
: Press the soft key (
the cordless handset. Press [OFF] to go to the standby mode.
• To exit the menu, press [STOP] or [OFF].
To confirm the security mode you set, press [ADT] in the standby mode.
Arming the System
g
g
Example
ARMED
You may exit now
), and follow steps 2 to 3 above, using
ADT
ARM
STAY
STAY
;;;
;;;
9
Advertisement
Chapters
Table of Contents
