Yealink T48G-SKYPE FOR BUSINESS EDITION User Manual page 59

To configure a static IPv4 address via phone user interface:
Tap ->Advanced (default password: admin) ->Network->WAN Port->IPv4.
1.
Tap Static IP from the pull-down list of Type.
2.
Enter the desired value in the IP Address, Subnet Mask, Gateway, Pri.DNS and Sec.DNS
3.
field respectively.
Tap to accept the change or tap
4.
You can configure a static IPv6 address for the Skype for Business phone. Before configuring it,
make sure that the IP mode is configured as IPv6 or IPv4 & IPv6.
To configure a static IPv6 address via phone user interface:
Tap ->Advanced (default password: admin) ->Network->WAN Port->IPv6.
1.
Tap Static IP from the pull-down list of Type.
2.
Enter the desired value in the IP address, IPv6 IP Prefix, Gateway, Pri.DNS and Sec.DNS
3.
field respectively.
Tap to accept the change or tap
4.
If you are using an xDSL modem for IPv4 network connection, you can connect your phone to
the Internet via PPPoE mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a
to cancel.
to cancel.
Getting Started
45