Yealink T4 Series How To Configure
Hide thumbs
Also See for T4 Series:
- Quick start manual ,
- User manual (253 pages) ,
- Registering and using (16 pages)
Advertisement
Table of Contents
2/28/2019
How to configure T4 Series for 3CX
This guide applies to v15.5 only.
On this topic
Supported Models: Yealink T4 series
Step 1: Upgrade to the Required firmware
Local LAN or SBC: Provision via Plug'n'Play
Supported Models: Yealink T4 series
● Yealink T40G
● Yealink T40P
● Yealink T41P
● Yealink T41S
● Yealink T42G
● Yealink T42S
● Yealink T46G
● Yealink T46S
● Yealink T48G
● Yealink T48S
Step 1: Upgrade to the Required firmware
Ensure that the phone is running on the required firmware by 3CX. In case the device needs manual updating
download the latest distributed required firmware by 3CX
https://www.3cx.com/sip-phones/yealink-t4-series/
Auto Provision your Yealink T4 series IP Phone for 3CX v15
here.
Read how to check what firmware the phones
1/5
Advertisement
Table of Contents
Related Manuals for Yealink T4 Series
Summary of Contents for Yealink T4 Series
- Page 1 2/28/2019 Auto Provision your Yealink T4 series IP Phone for 3CX v15 How to configure T4 Series for 3CX This guide applies to v15.5 only. On this topic Supported Models: Yealink T4 series Step 1: Upgrade to the Required firmware...
- Page 2 2/28/2019 Auto Provision your Yealink T4 series IP Phone for 3CX v15 are running on and how to upgrade them in this guide: How to manual upgrade Yealink IP phones. Step 2: Factory Reset the IP Phone Before provisioning the IP phone, the phone must be brought back to factory defaults in case the device has residual settings of a previous configuration.
- Page 3 2/28/2019 Auto Provision your Yealink T4 series IP Phone for 3CX v15 4. All major provisioning settings are pre-populated. If your PBX has multiple network cards, select to which network this IP phone is connected. 5. Click “OK”. The phone will configure automatically and will reboot to finalize the setup.
- Page 4 2/28/2019 Auto Provision your Yealink T4 series IP Phone for 3CX v15 5. Switch the “Provisioning Method” to “Direct SIP (Stun - Remote)” and click “OK”. 6. You can make sure that the extension is ready to be configured via RPS by checking the “Event Log”...
- Page 5 2/28/2019 Auto Provision your Yealink T4 series IP Phone for 3CX v15 Note: Ensure that the input mode is set to digits (green box). Step 4: Extended Phone Configuration IP phones can be tweaked to match the user’s needs. Those might be skipped if they are not desired and the phone will be rolled out in a default configuration.
Need help?
Do you have a question about the T4 Series and is the answer not in the manual?
Questions and answers