Exit - Wirepath Surveillance WPS-750-DOM-AH-WH Installation Manual

BAUD RATE
Choose a baud rate for RS-485 communication between the camera
and controller. Baud rate options include 4800, 9600, 19200, 38400,
and 57600, and must be set to the same rate in all of the devices.
Warning: Confirm that all devices in the system use the same Baud Rate.
SAVE/REBOOT
Once changes have been made to the COMM SETTINGS, Save and
Reboot the camera to retain the settings. These settings are stored
even when the Factory Default settings are applied. Select
SAVE/REBOOT and press the MENU button.
PREVIOUS
Return to previous page.

EXIT

1. Select EXIT to exit the OSD menu.
2. Attach the Dome to the Camera
Note: The camera is equipped with Silica packs that absorb moisture in the
camera to prevent condensation on the lens. DO NOT remove the Silica pack
unless it is being replaced.
A. Replace the dome cover to the
dome base, and make sure the
screws on the dome cover are
tightened securely. Doing so seals
the dome from the elements,
and creates a tight fit around the
rubber lens gasket to prevent the
IR LEDs from reflecting into the lens.
© 2013 Wirepath Surveillance
- DISPLAY ID: Set DISPLAY ID to ON to display the
CAMERA ID on the screen. This feature is useful when
needing to know the ID of a camera simply by viewing
a picture.
- ID POSITION: Select the position for the CAMERA ID
on the display screen by using the left and right arrows
"", "" to move the ID.
- PREVIOUS: Return to previous page.
WPS-750-DOM-AH Installation Manual
Lens Rubber Gasket
25