Day/Night - Wirepath Surveillance WPS-750-DOM-AH-WH Installation Manual

DAY/NIGHT

• Set the DAY/NIGHT value to AUTO,
DAY, NIGHT, or EXT based on the
installation application.
• DAY: The camera remains in color
mode all of the time.
• NIGHT: The camera remains in black and white (B/W) all of the time.
• EXT: This mode uses the external sensor in the camera to switch
to color or B/W. This is the recommended setting.
• AUTO: The camera uses the lens to determine color or B/W. When in
AUTO mode, the camera automatically switches to B/W when lighting
levels are low, and back to color when they increase.
Note: AGC must be enabled for AUTO mode to be an option in the
DAY/NIGHT menu.
AUTO Setting
When setting the DAY/NIGHT mode to
AUTO, the camera uses the lens to detect
the Lux rating of the picture and switches
to color or B/W automatically. Press the
MENU button to set the switching time
and speed for AUTO mode.
• D/N LEVEL: Select the sensitivity of switching between color and B/W.
Set the value to "LOW", "MIDDLE" or "HIGH" mode based on the
environment of where the camera is installed. The "HIGH" level
switches the camera to color or B/W with less change in the lighting
level than the LOW mode.
• FILTER DLY: Select the delay time before the camera switches
between color and B/W mode by changing the filter delay. The delay
time can be set to 1SEC, 3SEC, 5SEC, 10SEC, 15SEC, 30SEC and 60SEC.
• NIGHT BURST
- ON: The B/W image is actually a gray image and contains the
color signal.
- OFF: This is a true B/W image containing no color signal.
• INITIAL SET: Returns the Day/Night Auto settings to factory default
settings.
• PREVIOUS: Return to the previous page.
© 2013 Wirepath Surveillance
WPS-750-DOM-AH Installation Manual
<MAIN MENU>
1. CAM NAME OFF
2. LENS DC IRIS
3. EXPOSURE
4. DAY/NIGHT DAY
5. WDR/BLC/ECLPS WDR
6. WHITE BAL ATW
7. 3D-DNR ON
8. EFFECTS
9.SPECIAL
0. EXIT RET
<D/NIGHT AUTO MENU>
D/N LEVEL MIDDLE
FILTER DLY 10SEC
NIGHT BURST OFF
INITIAL SET
PREVIOUS
17