Cab-1 Remote Controller Numeric Keypad Commands - Lionel Canadian Pacific Freight Owner's Manual

TrainMaster Command Control operations

CAB-1 Remote Controller numeric keypad commands

W hen you press the AUX1 button on your CAB-1 Remote Controller,
you turn the numeric keypad into ten command buttons. These
commands are specific to your locomotive, and an overlay is included to
help you learn these functions. After you press the AUX1 button, you
will be able to press any numbered button until you address a different
Command Control equipped product. The corresponding
RailSounds sound system effects are in bold italic type.
Stops and resets the locomotive. Resets the locomotive's direction to forward. Resets the
RailSounds sound system to automatic RPM operation. Horn blows. RPM sounds
return to automatic.
Raises the volume of the RailSounds sound system. Sound volume increases.
Activates CrewTalk communication, unintelligible radio dialogue. CrewTalk commu-
nication.
Increases the RailSounds sound system RPM level. Starts the RailSounds sound system.
RPM level increases. Start-up sequence commences.
Lowers the volume of the RailSounds sound system. Sound volume decreases.
Activates the shutdown sequence. Like prototypical locomotives, the RPM level must be at
idle for shutdown to occur. Press 6 repeatedly to lower the RPM level until the RPM
sounds reach idle. Press 5 to initiate the shutdown sequence and listen for the CrewTalk
communication. Keep in mind that the horn, bell, and RPM sounds are inactive until you
restart the RailSounds sound system by pressing 3. CrewTalk communication.
Diesel shutdown sequence.
Lowers the RailSounds sound system RPM level. RPM level decreases.
Activates a TowerCom announcement, which includes a call-out specific to your locomo-
tive. Pressing 7 the first time triggers a "hold for clearance" message. Press 7 again, and
a "clear for departure" message plays. There is a four-second delay in this function.
TowerCom announcement.
Turns off the smoke unit. Air release sound.
Turns on the smoke unit if the smoke unit switch is in the ON position. Be sure to add
smoke fluid before turning on the smoke unit to prevent damage to your locomotive. Air
release sound.
AUX1, 8 and 9 function only if the locomotive's smoke unit switch is in the ON
Note!
position.
21
AUX1