Table of Contents
Advertisement
Operating and servicing your train set
Replacing the lamp in your extended vision caboose
D
uring the course of normal operation, the lamp inside your caboose may require replace-
ment. Follow these steps and refer to Figure 10 as you replace the lamp.
1. Remove the screws from both ends of the car.
2. Remove the end platforms, then lift the body and window shell off the frame.
3. Pull the lamp out of the socket and replace it with part no. 600-0161-300, available from
your authorized Lionel Service Center or Lionel Service.
4. Place the body and window insert back onto the frame and slide the end platforms back
into place.
5. Complete the lamp replacement by installing the two end screws.
Window
shell
End
platform
Lamp no. 600-0161-300
Figure 10. Latern installment and lamp replacement
Smoke
ON
unit
OFF
switch
33
End platform
Advertisement
Table of Contents
