Installing The Battery - Lionel Canadian Pacific Freight Owner's Manual

RailSounds sound system operations

Installing the battery

W hile the RailSounds sound system is powered through the track, we recommend that you
install a nine-volt alkaline battery to prevent the sound system from shutting down dur-
ing track power interruptions (for example, at a switch or a dirty section of track). Follow
these steps and refer to Figure 6 as you install the battery.
If the RailSounds sound system turns off during interruptions in track power, you
Note!
may need to replace the battery.
1. Carefully unsnap and remove the rear radiator hatch.
2. Remove the protective cover from the battery harness.
3. Snap the battery harness onto the nine-volt alkaline battery's terminals.
4. Slide the battery into the battery clip.
5. Replace the hatch.
Battery harness
Volume control knob
Battery holder
Figure 6. Battery installation and volume control knob location
Radiator hatch
14