Cab-1 Remote Controller Numeric Keypad Commands - Lionel SD70MAC Owner's Manual

Diesel locomotive
Table of Contents

Advertisement

TrainMaster Command Control operations

CAB-1 Remote Controller numeric keypad commands

W
hen you press the AUX1 button on your CAB-1 Remote Controller, you turn the numeric
keypad into ten command buttons. After you press the AUX1 button, you will be able
to press any numbered button until you address a different product. The corresponding
RailSounds sound system effects are in italic type.
Stops and resets the locomotive. Resets the locomotive's direction to forward. Your
locomotive keeps track of its fuel level. Higher engine speeds and/or heavy labor will use
fuel at a faster rate. Press AUX1, 2 to initiate engine status dialog, including the fuel level.
To add fuel, perform a "long reset." When the fuel level is low (or at any time), you may
choose to press and hold AUX1, 0 for at least three seconds. You will hear the sounds of
fuel flowing into the tank as long as you hold the button. When you release the button, the
sounds will stop and the engineer will confirm that the tank is full. Refueling sequence.
Raises the overall master volume of the LEGACY RailSounds sound system. To
independently adjust the level of the background sounds only (e.g., the diesel roar and
brake sounds), tap AUX1 and then this key. Sound volume increases.
When adjusting the overall volume, you'll hear a single bell hit that gets louder or softer
with each volume adjustment. When the volume is at maximum, additional button
presses have no effect and won't play the bell. When adjusting the background sounds
(AUX1, then a volume key) you'll hear the prime mover volume change without a single
bell hit.
Engineer begins radio dialog, dispatcher replies (see page 18). CrewTalk communication.
Enters manual RPM mode and increases the RailSounds sound system RPM level. If the
LEGACY RailSounds sound system is shut down (see 5 key below), AUX1, 3 activates a full
LEGACY RailSounds sound system start-up while the locomotive is stopped after pressing
AUX1, 5 with track power on.
21

Advertisement

Table of Contents
loading

Table of Contents