Table of Contents
Advertisement
TrainMaster Command Control operations
CAB-1 Remote Controller numeric keypad commands
W
hen you press the AUX1 button on your CAB-1 Remote Controller, you turn the numeric
keypad into ten command buttons. After you press the AUX1 button, you will be able
to press any numbered button until you address a different product. The corresponding
RailSounds sound system effects are in italic type.
Stops and resets the locomotive. Resets the locomotive's direction to forward.
To add fuel, perform a "long reset." Press and hold AUX1 and 0 for at least three seconds.
You will hear the sound of fuel pouring into the engine's tank for as long as you hold the
button. When you release the button, the loading sound will stop. Refueling sequence.
Raises the overall master volume of the RailSounds sound system. To independently adjust
the level of the background sounds only (e.g., the diesel roar and brake sounds), tap AUX1
and then this key. Sound volume increases.
When adjusting the overall volume, you'll hear a single bell hit that gets louder or softer
with each volume adjustment. When the volume is at maximum, additional button
presses have no effect and won't play the bell. When adjusting the background sounds
(AUX1, then a volume key) you'll hear the volume change without a single bell hit.
Engineer begins radio dialog, dispatcher replies.
Enters manual RPM mode and increases the RailSounds sound system RPM level. If
the RailSounds sound system is shut down (see 5 key below), AUX1, 3 activates a full
RailSounds sound system start-up while the locomotive is stopped after pressing AUX1, 5
with track power on.
25
Advertisement
Table of Contents
