Reset The Camera To The Factory Default Settings - Panasonic KX-HCM10 Operating Instructions Manual

3.2 Reset the Camera to the Factory Default
settings
The Network Camera has an CLEAR SETTING button which is located on back
panel.
To Reset the Camera to the Factory Default Settings
If any of the user settings or password were forgotten the Network Camera can be
easily reset to the factory default settings. With power applied, press the "CLEAR
SETTING" for about 1 second. The green LED on the front of the camera will first
go out, and will blink for about 45 seconds during which time the pan - tilt motors
will reposition themselves. The entire procedure takes about 1 minute. The reset
is located on the rear of the camera and is accessed through the hole in the case
using a pointed object.
CAUTION
When you press the CLEAR SETTING button, all buffered images are cleared.
72
CLEAR SETTING button
(Press this button with a
pencil or a similar object)
Operating Instructions