Panasonic KX-HCM10 Operating Instructions Manual page 53

Operating Instructions
Instructions for the data fields
a.
It is possible to buffer or transfer by alarm trigger. Alarm event is
generated by Digital Input Terminal. (Please refer to Section 3.1 I/O
Connector).
b.
Active Time of Trigger is set up.
c.
Always : Always active the alarm trigger.
Operational between : Operational between start and stop time,
please select the desired time.
Alarm enable condition : Please select the [Rising] or [Falling] of
digital input terminal edge. When you setup over a day, please check
the day of the week on a start day.
d.
Secondary time is only active outside of the time period established
for Primary Time. Please check Enable, when you use.
Alarm enable condition : Please select the [Rising] or [Falling] of
digital input terminal edge.
e.
It is possible to select the buffering Image Resolution and Quality.
Resolution : 640x480/320x240/160x120
Quality : Favor Clarity/Standard/Favor Motion
f.
It is possible to select the enable buffer about the Pre and/or Post
trigger. Please check Enable, when you select.
g.
Image Frequency : It is target frequency of buffer.
Maximum number of image per each trigger : total image number is
determined by memory size, Image Resolution/Quality and target
image.
Example : 320x240, Standard = about 80 images.
h.
It is possible to select Transfer Method. Please select only one
method.
Non Transfer/FTP/Mail
i.
Buffering only
It is possible to use the [Primary], [Secondary] on Buffering image
viewer.
j.
FTP : File Transfer Protocol
Please setting the following items.
Server Address* or Host Name**, Port No.***, Login ID for access to the
FTP server**, Password for access to the FTP server**, Upload File
Name at full pass**.
*: Same as the character setting of IP Address.
**: Can not use [Space], ["], ['], [#], [&], [%], [=], [+], [?], [<], [>], [:] (only
ASCII character codes 33-126)
[For assistance : 1-800-272-7033] 53