Panasonic KX-HCM10 Operating Instructions Manual page 68

2.
When you need to reset to Factory Default, click the
The Reset to Factory Default button allows you to initialize all the parameters
of the Network Camera to the factory default, including the ID, Password, IP
Address and Subnet Mask.
• To undo the reset click
Then it returns to Setup Page, without reset to Factory Default.
Information
• Please refer to Section 3.2 Reset the Camera to the Factory Default
settings.
• You can also operate the "Reset to Factory Default" by pushing the
"CLEAR SETTING button" a few seconds, located on the side panel.
Please refer to Section 3.2 about the "CLEAR SETTING button"
CAUTION
1.
Buffered images are erased when you execute this page.
2.
Never turn off the power, during the Reset to Factory Default.
3.
Please refer to "Getting Started Manual" to open this Network Camera, after
execute this page. Because setting condition will be changed. Especially,
IP Address : Changed to 192.168.0.253
Subnet Mask : Changed to 255.255.255.0
68
Cancel
.
Operating Instructions
Execute
button.